JREB.ORG

I'm currently (finally getting too) doing 5835 and I know that the middle fan was removed was there a round plate or a entirely new section there I can't find any roof shots

Thanks : Eric

There is a very thin square sheet metal plate that fills almost the entire area between the two remaining fans.  You can see it in this photo if you look very carefully:

http://www.rrpicturearchives.net/showPicture.aspx?id=2230479

Chris

Thanks Chris I can handle that lol I have a thin sheet of brass that looks like paper cost as much as a new car (model railcar)

Badhorse,
Why are you using brass? I would think a piece of styrene would work. (easier to cut, sand, etc...)

This is true and thats what I did Almost used putty and thought noooo thanks so it's all finished and needs decals witch hopefully will be here tomorrow

heres a few pics of the finished Geep

some more

one more

hope ya all like it , my next projects are

NS SW1500 2316 almost finished
NS SD45-2 1704 waiting on parts
and NS SD40-2 1641 still in box

Looking good Badhorse79.

As in the other forum that we started about the 38-3, what decal did you use for the HH decal? N scale or the Ho sheet?

I used the little sheet extra from microscales HH set 87-1225 the OLS set is from Shellscale

Looking good... once again. : )